GeeThree: Multiport


		Installing the Sweet Multiport - G4 AGP, Gigabit Ethernet
		1. Before opening your computer, shut it down. 2. Unplug all the cables and power cord. 3. Open the latch on the side of your system. 4. Remove the front faceplate cover assembly for the drive bay. There are two clips behind the faceplate. Press those clips and rotate the assembly forward to remove it.

		5. Remove the two screws that hold the lower drive bracket in place. 6. Slide the lower drive bracket forward. 7. Insert the Sweet carrier with the front panel card and interconnect cable into the drive bracket. As you insert the carrier, make sure that the interconnect cable is goes in first and goes out the back of the bracket.

		8. Fasten the Sweet carrier in place with four screws. 9. Reinstall the two screws that hold the drive bracket in place. 10. Remove the lower faceplate cover. There are four tabs that hold the cover in place. Replace this cover with the new Sweet Multiport faceplate cover.

		11. Reinstall the faceplate assembly by aligning the left edge to the case, and rotate the right side until the clips snap into place.
		12. The last step is to install the Sweet PCI card.